How to Replace a Rear View Mirror

The way to replace the rearview mirror is as follows:
1. Prepare a screwdriver and pry open the edge of the mirror shell and the reflector base.
2. Insert the screwdriver into the gap between the mirror plate and the mirror shell.
3. Extend the screwdriver into the gap between the mirror plate and the mirror shell.
4. Remove the mirror shell and pull out the harness of the mirror plate.
5. Pry open the clip that holds the mirror plate and take out the mirror plate.
6. Take out the new mirror plate and install it, and then adjust the rearview mirror back to its normal position.
Precautions for replacing the rearview mirror are as follows:
1. Pay attention to distinguishing the letters of the rearview mirror, the left driving mirror plate with the letter L, and R represents the right passenger seat.
2. When installing the new rearview mirror, use needle-nose pliers to peel the residual metal wire skin on the rearview mirror, screw together with the copper wire at one end of the heating wire, and wrap with insulation tape; manually connect the metal clip at one end of the heating wire to the bayonet above the black plastic card on the back of the lens; Put the connected lens into the rear view mirror housing, adjust the position, and press slowly and firmly.

Replacing a rearview mirror can vary depending on the type of mirror and the specific make and model of your vehicle. Below is a general guide for replacing a standard rearview mirror. Keep in mind that these steps may not cover all possible scenarios, and it's important to refer to your vehicle's manual for model-specific instructions.

Tools and Materials:

• Replacement rearview mirror
• Screwdriver (flathead or Phillips, depending on your mirror)
• Adhesive remover (if your mirror is attached with adhesive)
• New adhesive (if needed)
• Safety glasses

Steps:

1. Purchase the Replacement Mirror:

   • Ensure that the replacement mirror is compatible with your vehicle's make and model. You can purchase replacement mirrors at auto parts stores or online.

2. Locate the Set Screw or Mounting Bracket:

   • Inspect the base of the existing mirror for a set screw or mounting bracket. This may be covered by a plastic or rubber cover.

3. Remove the Set Screw or Loosen the Mounting Bracket:

   • If there's a set screw, use the appropriate screwdriver to loosen and remove it. If there's a mounting bracket, you may need to loosen it using the correct tool.

4. Detach the Mirror:

   • Once the set screw or mounting bracket is removed, carefully detach the mirror from the mounting bracket. Some mirrors have a ball-and-socket joint, so you might need to lift or twist the mirror to release it.

5. Disconnect Wiring (if applicable):

   • If your rearview mirror has electrical components (such as auto-dimming or heating features), there may be wiring connected to it. Carefully disconnect any wiring, following the manufacturer's instructions.

6. Remove Adhesive (if applicable):

   • If the mirror is attached with adhesive, use an adhesive remover to dissolve the adhesive. Follow the product instructions and take care not to damage the windshield. Clean the mounting area thoroughly.

7. Attach the New Mirror:

   • If the new mirror has a mounting bracket, secure it in place according to the manufacturer's instructions. If it's attached with a set screw, insert the screw and tighten it.

8. Connect Wiring (if applicable):

   • If your new mirror has electrical components, connect the wiring as per the manufacturer's instructions.

9. Final Adjustments:

   • Adjust the new mirror to your preferred position.

Note:

• Always refer to your vehicle's manual for specific instructions related to your make and model.
• If the mirror is attached with adhesive, make sure to use a high-quality automotive adhesive for the replacement.
• If you're uncomfortable with the replacement process, consider seeking professional assistance to ensure proper installation and safety.